Before starting work on the construction of earthen structures should be tested are in conformity with the design documentation and the actual performance of composition and state of the soils in the quarries, reserves, pits, natural grounds. Code.org brings even more insight to the discussion. Composition (species, variety) and the humidity of soil samples determined in industrial laboratories by the method described in the existing regulations. The data input control provisions make out statement. At the same time takes samples of samples without disturbing their natural state to determine the density of soil needed to determine the actual amount of earthwork. Used in the construction of earthworks and the device ground soil shall meet the requirements of project documents. Further details can be found at Castle Harlan, an internet resource.
A discrepancy of actual performance type of soil, moisture, or other characteristics to the design data, if these differences can affect the quality of construction or production technology works, the contractor is obliged to suspend work. Replacement of the project design primers, members of the erected structure or its foundation, is allowed only in agreement with the project organization and the customer. At the stage entrance control construction company is set up soil compaction process, ie, refined the process parameters and operating modes of sealing machines. Setting the process is carried out by soil compaction test seal. In the development of reserves (grooves, pits) conducted systematic observations of change neniem soil moisture depending on the conditions of moistening and drying. Sampling for moisture should be made in accordance with the directions of the project documentation. Results of the determination (measurement) of humidity recorded in the general journal papers. Monitorable indicators for constant quality seal earthen structures include: – density of the natural base (before the device overlying earthen structures, device, or laying the foundation design) – uniformity in the layers of the mound of soil composition and moisture – density and humidity of soil in the embankment layers – the evenness of the surface compacted layer and its thickness – compliance with transverse slopes. The special conditions (embankment on weak grounds, subsiding soils, etc.) in the design documentation can be provides other indicators that are also subject to continuous monitoring with the fixation of possible deviations.
Creating a home system, offering control of lighting, should be a rational approach to the selection of the minimum required for this technical means, taking into account the inevitably arise in this work. If you already have a good lighting system, it is advisable to use wireless devices that enable management to control lighting remotely, and remote control devices with independent power supply is even better. Installation of new or additional cables may prove a more expensive wireless systems offering control of lighting. Very simple and practical solution could be to socket with light barrier, sensor or timer. By installing it, you will immediately receive a lighting control for one or for a group of lighting devices. Devices with self-powered with batteries are quite reliable. Power consumption these devices are so small that one set of batteries safely run for the whole year. Self-powered and can be simply indispensable when removing from the power significantly.
System implementing lighting controls will bring you considerable time savings and comfort. However, the maximum economic effect can be achieved only by using modern energy-saving lamps. For small current consumption they give plenty of light. Even forgotten by all conventional fluorescent lamps, consuming 36 W, give as much light as regular incandescent lamp of 200 watts. Cheap fixtures with lamps release and in waterproof performance.
For street lighting is best to use high-pressure discharge lamps. They are creating an even more powerful light streams consume a miserly amount of energy and are the most durable. At the same time allow you to implement and highly original color effects. Lighting Control outside can be trusted and the timer (programmable timer). In most cases these devices can be easily installed directly into existing lighting and require no additional work.